Program Codes 427
Advanced Feature Codes
Kerf Table
Code Description
G59 D1-200Xvalue Sets kerf table variable from 1-200
G41 D1-200 Enables Left Kerf using a Kerf Table variable
G42 D1-200 Enables Right Kerf using a Kerf Table variable
G43 D1-200 Changes current kerf value via Kerf Table using previously set Left or Right
kerf
Tilt / Rotator Part Codes
Code Description
G00 Avalue Sets Tilt angle as a preparatory command – A is the angle value in degrees
G00 XYvalue Avalue Performs Linear Interpolation of Tilt angle along line segment.
G00 Avalue Fvalue Sets Tilt angle – Angle value in degrees with a speed command in RPM
M28 Disables Follower
M29 Enables Follower
M90 Preparatory Cmd - Aligns Rotator to Tangent angle of next cut segment
M90- Align rotator when not using shortest path motion
M75 A axis/Tilt Goto Home Cmd - Rapid Index
G00 Cxx Move to rotate “C” position
G01 Cxx Fxx Move to rotate “C” position with Speed “F” command
G00 C180- Rotate Axis align 180 degrees will continue to rotate in the proper direction
G00 C-180- Rotate Axis align -180 degrees will continue to rotate in the proper direction
G01 C180- Fxx Rotate Axis align 180 degrees with speed
G01 C-180- Fxx Rotate Axis align -180 degrees with speed
Automatic Torch Spacing Program Codes
Code Description
M32 Unclamp / Unlock All Stations
M33 Unclamp / Lock All Stations
M34 Clamp / Unlock All Stations
M34Tvalue Clamp / Unlock „T” Station, where T = 1 through 19
M35 Clamp / Unlock All Stations Mirror
M35Tvalue Clamp / Unlock Mirror “T” Station, where T = 1 through 19
M77 Go to Home position Y Axis
M78 Go to Home position X Axis
To Next Page
Loading...
Need help?
General
