Hypertherm MicroEdge User Manual

Program Codes 424
ESSI CODE DESCRIPTION MAPPED TO EIA
11+7 Marker Offset 7 On M283
12+7 Marker Offset 7 Off M282
11+8 Marker Offset 8 On M285
12+8 Marker Offset 8 Off M284
13 Enable Marker 2 M13
14 Disable Marker 2 M14
15 Marker Offset 2 On M73
16 Marker Offset 2 Off M72
21 No Mirror, No Rotate G99 X1 Y0 I0 J0
22 Mirror Y, No Rotate G99 X1 Y0 I0 J1
23 Mirror X and Y G99 X1 Y0 I1 J1
24 Mirror X, No Rotate G99 X1 Y0 I1 J0
25 Mirror X/Y on -45 Deg G99 X1 Y270 I1 J0
26 Rotate 90 Deg CCW G99 X1 Y90 I0 J0
27 Mirror X/Y on +45 Deg G99 X1 Y270 I0 J1
28 Rotate 90 Deg CW G99 X1 Y270 I0 J0
29 Enable Left Kerf Comp G41
30 Enable Right Kerf Comp G42
38 Disable Kerf G40
39+value Machine Speed Fvalue
40+value Programmable Kerf G43 Xvalue
41 Preset Dwell G04
41+value Program Dwell in mSec G04 Xvalue
45 Ht Sensor Enable/Lower M53
46 Ht Sensor Disable/Raise M52
47 Ht Sensor Enable M51
48 Ht Sensor Disable M50
51 CBH Enable M29
52 CBH Disable M28
53 Cutting Device On M07
54 Cutting Device Off M08
63 Reset Functions M31
64 End Program M02
65 End of Program/ Reload M65
67 Ht Sensor Disable M50
68 Ht Sensor Enable M51
70 Select English Units (in) G20
71 Select Metric Units (mm) G21
79+1 Go To Home Position 1 M79 T1
79+2 Go To Home Position 2 M79 T2
79+3 Go To Home Position 3 M79 T3
79+4 Go To Home Position 4 M79 T4
81 Incremental Mode G91
82 Absolute Mode G90
83 Set Axis Presets G92
90 End of Program M02
97 Program Repeat Pointer G97
97+value Subroutine Loop M40 Xvalue
98 Repeat at 97, Subroutine loop G97, G98 or M41 as appropriate
or start of program if no 97
99 End of Program M02

Hypertherm MicroEdge Specifications

General

Brand	Hypertherm
Model	MicroEdge
Category	Control Systems
Language	English