• If you do not specify a route, the test is performed for all routes associated with the
address-family identifier.
• Specifying only an address and mask without a route distinguisher causes all routes
sharing the address and mask to be taken into account. Specifying only an address
causes a best match to be performed for the route.
• If you completely specify a route with IP address, mask, and route distinguisher, the
command displays detailed route information. Otherwise only summary information
is shown. Use the fields option to select particular fields of interest.
• If you specify a BGP peer group by using the peerGroupName argument, all the members
of the peer group inherit the characteristic configured with this command unless it is
overridden for a specific peer.
• You can set a weight value for inbound routes filtered with a filter list.
• Example
host1#test ip bgp neighbor 10.12.54.21 advertised-routes distribute-list boston5 fields
all
• There is no no version.
• See test bgp ipv6 neighbor.
• See test ip bgp neighbor.
155Copyright © 2010, Juniper Networks, Inc.
Chapter 1: Configuring BGP Routing
To Next Page
Loading...
Need help?
General
