To Next Page

To Previous Page

Table 131: show vpls connections Output Fields

Field DescriptionField Name

Name of the VPLS instance for which information is displayedBridgeGroup

Bridging capability currently enabled; for a VPLS instance, this field

always displays default

Bridge Mode

Length of time, in seconds, that a MAC address entry can remain in

the forwarding table before expiring

Aging Time

Whether acquisition of dynamically learned MAC addresses is

enabled or disabled

Learning

Maximum number of dynamic MAC addresses that the VPLS

instance can learn

Max Learn

Whether SNMP link status processing is enabled or disabledLink Status Snmp Traps

Name of the subscriber policy currently in effectSubscriber Policy

Number of ports currently configured for the VPLS instance,

including network interfaces and the VPLS virtual core interface

Port Count

Number of network interfaces currently configured for the VPLS

instance

Interface Count

Name of the transport virtual router configured for the VPLS instanceTransport Virtual Rtr

Unique route distinguisher configured for the VPLS instanceRoute Distinguisher

Site name configured for the VPLS instanceSiteName

Identifier for the PE router that acts as the transport virtual router

for the VPLS instance

Transport Virtual Rtr

Priority of the VPLS instance to serve as the backup PE router for

the CE device in the event of a network failure in the multihomed

configuration; indicates also that the site is multihomed

Multihomed priority

Numerical site identifier configured for the VPLS instanceSiteId

Maximum number of sites that can

participate in the VPLS domain associated with the VPLS instance

SiteRange

Extended community identifiers, also known as route targets, for

each VPLS instance configured on the router

VPLS Route Targets

JunosE 11.2.x BGP and MPLS Configuration Guide

Juniper JUNOSE 11.2.X BGP AND MPLS User Manual

Questions and Answers: