Juniper JUNOSE 11.2.X BGP AND MPLS User Manual

•
Monitoring MPLS Status and Configuration on page 343
•
Monitoring MPLS Explicit Paths on page 345
•
Monitoring the RSVP-TE Bypass Tunnels on page 346
•
Monitoring MPLS Labels Used for Forwarding on page 347
•
Monitoring MPLS Interfaces on page 348
•
Monitoring MPLS Minor Interfaces on page 354
•
Monitoring MPLS Next Hops on page 355
•
Monitoring the Configured Mapping between PHB IDs and Traffic Class/Color
Combinations on page 356
•
Monitoring RSVP-TE Profiles and MPLS Tunnel Profiles on page 357
•
Monitoring RSVP Path State Control Blocks, Reservation State Control Blocks, or
Sessions on page 358
•
Monitoring RSVP MD5 Authentication on page 362
•
Monitoring RSVP-TE Interfaces Where BFD is Enabled on page 362
•
Monitoring RSVP-TE Interface Counters on page 363
•
Monitoring RSVP-TE Graceful Restart on page 365
•
Monitoring RSVP-TE Hello Adjacency Instances on page 366
•
Monitoring Status and Configuration for MPLS Tunnels on page 368
•
Verifying and Troubleshooting MPLS Connectivity on page 370
•
Packet Flow Examples for Verifying MPLS Connectivity on page 372
•
Troubleshooting MTU Problems in Point-to-Point LSPs on page 379
Setting the Baseline for MPLS Statistics
You can use the baseline mpls commands to set a statistics baseline for MPLS operations.
The router implements the baseline by setting the statistics to zero and then subtracting
this baseline when you retrieve baseline-relative statistics.
Use the delta keyword with the show mpls commands to display baselined statistics.
Tasks to set a baseline for MPLS statistics are:
•
Setting a Baseline for MPLS Major Interface Statistics on page 322
•
Enabling and Setting a Baseline for MPLS Forwarding Table Statistics on page 323
•
Enabling and Setting a Baseline for MPLS Next-Hop Table Statistics on page 323
•
Setting a Baseline for MPLS Tunnel Statistics on page 324
•
Enabling Statistics Collection for Policies Attached to MPLS Tunnels on page 324
Setting a Baseline for MPLS Major Interface Statistics
To set a statistics baseline for MPLS major interfaces:
•
Issue the baseline mpls interface command for a specific MPLS major interface.
Copyright © 2010, Juniper Networks, Inc.322
JunosE 11.2.x BGP and MPLS Configuration Guide

Juniper JUNOSE 11.2.X BGP AND MPLS Specifications

General

Brand	Juniper
Model	JUNOSE 11.2.X BGP AND MPLS
Category	Software
Language	English