LSPs used for IP forwarding
for host addresses only
NOTE: The mpls keyword is optional and is provided for compatibility with non–E Series
implementations.
Meaning Table 63 on page 331 lists the show ldp command output fields.
Table 63: show ldp Output Fields
Field DescriptionField Name
IP address of label-switched routerLSR ID
State of FEC deaggregation, on or offFEC Deaggregation
Type of label advertised for the LSR that is the egress router for the
prefix, implicit null, explicit null, or a non-null label
Egress label
Label distribution control mode used by LDP for label distribution,
independent control, or ordered control
Label distribution control
mode
Configured values for the number of LDP session retry attempts
and the retry interval
LDP session retry
Configured value for the LDP session hold timeLDP session hold time
Interval at which LDP sends session keepalive messages, in secondsLDP session keepalive
interval
LDP targeted-hello hold time, in secondsLDP targeted-hello hold
time
LDP targeted-hello interval, in secondsLDP targeted-hello interval
Status of topology-driven LSP, enabled or disabledTopology Driven LSP
LSPs are placed in the IP routing table for forwarding plain IP traffic;
displayed only when the mpls ldp ip-forwarding command has
been configured. Indicates whether the LSPs that are used for IP
forwarding are host only, subject to a specified access list, or subject
to a specified prefix list.
LSPs used for IP forwarding
LDP protocol statisticsLDP proto stats
Number of LDP peers discoveredtotalPeersDiscovered
Number of LDP adjacencies establishedtotalAdjacenciesEstablished
Number of LDP sessions establishedtotalSessionsEstablished
331Copyright © 2010, Juniper Networks, Inc.
Chapter 5: Monitoring MPLS
To Next Page
Loading...
Need help?
General
