Juniper JUNOSE 11.2.X BGP AND MPLS User Manual

Hellos are on with an interval of 10000 and miss limit of 4
Graceful restart is ON
Restart time 60000 milliseconds
Recovery time 120000 milliseconds
• Additional detail shown when RSVP-TE graceful restart helper mode is enabled:
RSVP is enabled
...
Graceful restart is ON (helper mode)
Meaning Table 72 on page 344 lists the show mpls command output fields.
Table 72: show mpls Output Fields
Field DescriptionField Name
Status of MPLS, administratively enabled or disabled, and
configuration status
MPLS
IP address of label-switched routerLSR ID
Frequency at which LSPs are checked for better pathsRe-optimization timer
Range of platform label spaceLabel range
Retry behavior to be performed during LSP setupretry
Status of loop detection, enabled or disabledLoop Detect
This field and the following fields are displayed only when LDP is
enabled.
LDP
IP address of label-switched routerLSR ID
State of FEC deaggregation, on or offFEC Deaggregation
Type of label advertised for the LSR that is the egress router for the
prefix, explicit-null or a non-null label
Egress label
Label distribution control mode used by LDP for label distribution,
independent control or ordered control
Label distribution control
mode
Interval in seconds between attempts to set up an MPLS LDP
session
LDP session retry
Period in seconds for which an LSR maintains the session with its
LDP peer without receipt of any LDP message from that peer
LDP session hold time
Interval at which LDP sends session keepalive messages, in secondsLDP session keepalive
interval
LDP targeted-hello hold time, in secondsLDP targeted hello hold
time
Copyright © 2010, Juniper Networks, Inc.344
JunosE 11.2.x BGP and MPLS Configuration Guide

Juniper JUNOSE 11.2.X BGP AND MPLS Specifications

General

Brand	Juniper
Model	JUNOSE 11.2.X BGP AND MPLS
Category	Software
Language	English