Table 117: Commands to Configure OSPF for a VPLS Network
router ospfnetwork area
To configure the PE router to set up OSPF routing for the core MPLS network:
1. Create the OSPF routing process.
host1(config)#router ospf 1
2. Create the range of IP addresses associated with the routing process and the
corresponding OSPF interfaces, and assign an area ID associated with each range
of IP addresses.
host1(config-router)#network 10.1.1.1 0.0.0.0 area 0.0.0.0
host1(config-router)#network 10.10.10.0 0.0.0.255 area 0.0.0.0
This example configures an OSPF routing process with process ID 1, and creates two
OSPF interfaces in the backbone area (area 0.0.0.0): one using IP address 10.1.1.1,
and one using IP address 10.10.10.0. The network area commands create the two
OSPF areas if they do not already exist.
Related Topics Configuring VPLS with LDP Signaling on a PE Router on page 602•
• For complete information about configuring and using OSPF, see the JunosE IP, IPv6,
and IGP Configuration Guide.
• For complete information about configuring and using IS-IS, see the JunosE IP, IPv6,
and IGP Configuration Guide.
• network area
• router ospf
Example: Configuring VPLS LDP Signaling
The example in this section shows how to configure the VPLS topology illustrated in
Figure 130 on page 606. The example includes the commands for configuring VPLS on
both the local E Series router (PE 1) and the remote E Series router (PE 2).
605Copyright © 2010, Juniper Networks, Inc.
Chapter 12: Configuring VPLS
To Next Page
Loading...
Need help?
General
