Related Topics show mpls forwarding•
Monitoring MPLS Layer 2 Interfaces for Layer 2 Services over MPLS
Purpose Display status and configuration information about MPLS layer 2 major, minor, and shim
interfaces. Both the show mpls interface shim command and the show mpls l2transport
interface command provide the same output. The shim keyword displays all shim
interfaces. The brief keyword displays only limited interface information.
Action To display information about MPLS layer 2 interfaces:
host1#show mpls interface shim
MPLS shim interface FastEthernet2/0
Remote PE address is 10.9.1.3
Virtual circuit ID is 1
Group ID is 0 by default
Control word is not preferred by default
Don't send sequence numbers by default
Relay format is ethernet by default
ATM VPI/VCI range is 1-2/100-109 (up on the line card)
ATM VPI/VCI range is 5-10/200-300 (up on the line card)
ATM cell aggregation is enabled
ATM cell aggregation maximum cells per packet is 20
ATM cell aggregation timeout timerId is 2
Administrative state is enabled
Operational state is down (shim interface does not have a next-hop)
Operational MTU is 1500
Received:
0 packets
0 bytes
1 error
0 discards
Sent:
0 packets
0 bytes
0 errors
0 discards
received mtu 0
queue 0: traffic class best-effort, bound to ethernet FastEthernet2/0
Queue length 0 bytes
Forwarded packets 0, bytes 0
Dropped committed packets 0, bytes 0
Dropped conformed packets 0, bytes 0
Dropped exceeded packets 0, bytes 0
MPLS policy input shimRl
classifier-group *
0 packets, 0 bytes
rate-limit-profile shimRl
committed: 0 packets, 0 bytes
conformed: 0 packets, 0 bytes
exceeded: 0 packets, 0 bytes
MPLS policy output shimRl
classifier-group *
0 packets, 0 bytes
rate-limit-profile shimRl
committed: 0 packets, 0 bytes
conformed: 0 packets, 0 bytes
exceeded: 0 packets, 0 bytes
Copyright © 2010, Juniper Networks, Inc.566
JunosE 11.2.x BGP and MPLS Configuration Guide
To Next Page
Loading...
Need help?
General
