host1#show ldp neighbor statistics
LDP Neighbor: 10.0.2.2
Message type Received Sent
---------------- -------- ----
Initialization 1 1
Keepalive 85 85
Notification 0 0
Address 1 1
Address withdraw 0 0
Label mapping 5 5
Label request 0 0
Label withdraw 2 2
Label release 2 2
NOTE: The mpls keyword is optional and is provided for compatibility with non–E Series
implementations.
NOTE: If a password is configured for a peer, you can view the password with the show
configuration command. This command displays the passwords in cleartext unless the
service password-encryption command has been issued, in which case the passwords
are displayed in encrypted format.
Meaning Table 68 on page 338 lists the show ldp neighbor command output fields.
Table 68: show ldp neighbor Output Fields
Field DescriptionField Name
IP address of LDP peerLDP neighbor
IP address of remote and local peers; the number following the
colon is the platform label space ID, and is always 0
LSR
Transport remote and local address for the TCP sessionTransport address
State of the session, nonexistent (session connection not
established) or operational (has received keepalive message)
State
Mode of label distribution, downstream-unsolicited or
downstream-on-demand
LDP advertisement
Time that the adjacency has been up, in hh:mm:ss formatUp
State of graceful restart, enabled or disabledGraceful Restart
State of graceful restart helper mode, enabled or disabledHelper Mode
Value for reconnect time received from peer in FT TLV, in
milliseconds
Reconnect Time
Copyright © 2010, Juniper Networks, Inc.338
JunosE 11.2.x BGP and MPLS Configuration Guide
To Next Page
Loading...
Need help?
General
