Table 99: show mpls l2transport load-balancing-group Output
Fields (continued)
Field DescriptionField Name
Information about the member interfaces for the circuitMember Interfaces
Interface specifier and status; active indicates it is being used for
traffic from the core; if active is not displayed, interface is not
currently being used for traffic, but the statistics may be valid
Interface
Number and type of candidate ports configured for the group,
including interface specifiers and state
member ports
Number of member circuits configured for each port and for the
group
member circuits
Related Topics show mpls l2transport load-balancing-group•
• show mpls l2transport interface
Monitoring MPLS Tunnels
Purpose Display status and configuration for all tunnels or for a specific tunnel in the current router
context
Action To display the configuration for all tunnels:
host12#show mpls tunnels
LSP vpnIngress-21 to 3.3.3.3
State: Up
Out label is Variable Interface
102 pkts, 0 hcPkts, 13464 octets
0 hcOctets, 0 errors, 0 discardPkts
Labels:
16 17 18 19
Meaning Table 100 on page 505 lists the show mpls tunnels command output fields.
Table 100: show mpls tunnels Output Fields
Field DescriptionField Name
Status of tunnel, up or downState
In the default case for a BGP/MPLS VPN, the Variable Interface,
which indicates that a packet exiting the interface is going through
a variable interface and that one of the labels listed further in the
display will be prepended to the packet
Out Label
Number of packets sent across tunnelpkts
Number of high-capacity (64-bit) packets sent across tunnelhcpkts
505Copyright © 2010, Juniper Networks, Inc.
Chapter 7: Monitoring BGP/MPLS VPNs
To Next Page
Loading...
Need help?
General
