Juniper JUNOSE 11.2.X BGP AND MPLS User Manual

Admin Oper
Interface Local-Site-Id Remote-Site-Id state state
--------------- ------------- -------------- ------- -----
FastEthernet4/1 1 2 enabled up
L2VPN: l2vpn2
Encapsulation Type ATM AAL5 SDU VCC transport
Use of control word is preferred
Send sequence numbers
Route Distinguisher 100:12
Site Range 20
Sites:
Site Name westford Site Id 1
Site Name boston Site Id 3
Route Targets:
Route Target: RT:100:2 both
Admin Oper
Interface Local-Site-Id Remote-Site-Id state state
---------- ------------- -------------- ------- -----
ATM2/0.122 1 2 enabled up
ATM2/0.123 1 3 enabled up
ATM2/0.124 3 1 enabled up
ATM2/0.121 3 2 enabled up
To display detailed information about a particular VPWS instance:
host1#show l2vpn instance l2vpn1 detail
L2VPN: l2vpn1
Encapsulation Type ATM AAL5 SDU VCC transport
Use of control word is preferred
Send sequence numbers
Route Distinguisher 100:11
Site Range 10
Sites:
Site Name westford Site Id 1
Multi-homed: Yes
Site-Priority: 45
Route Targets:
Route Target: RT:100:2 both
Admin Oper
Interface Local-Site-Id Remote-Site-Id state state
---------- ------------- -------------- ------- -----
ATM2/0.100 1 2 enabled up
ATM2/0.12 1 3 enabled up
ATM1/1.1 1 2 enabled down
Meaning Table 140 on page 674 lists the show l2vpn instance command output fields.
Table 140: show l2vpn instance Output Fields
Field DescriptionField Name
Name of VPWS instanceL2VPN
Encapsulation type configured for the VPWS instanceEncapsulation Type
Local preference for control word, preferred or not preferredUse of control word
Local preference for sequence number, send or don’t sendsequence numbers
Copyright © 2010, Juniper Networks, Inc.674
JunosE 11.2.x BGP and MPLS Configuration Guide

Juniper JUNOSE 11.2.X BGP AND MPLS Specifications

General

Brand	Juniper
Model	JUNOSE 11.2.X BGP AND MPLS
Category	Software
Language	English