Juniper JUNOSE 11.2.X BGP AND MPLS User Manual

host1(config)#mpls ldp graceful-restart
2. (Optional) Specify the length of time you want the neighbors to wait for the gracefully
restarting router to resume sending LDP messages to neighbors after the LDP
connection between them fails.
host1(config)#mpls ldp graceful-restart reconnect-time 130
3. (Optional) Specify the length of time the router retains its MPLS forwarding state
across a restart.
host1(config)#mpls ldp graceful-restart recovery-time 150
4. (Optional) Specify the maximum length of time that the router waits for a neighbor
to complete a graceful LDP restart after the LDP session is reestablished.
host1(config)#mpls ldp graceful-restart timers max-recovery 150
5. (Optional) Specify the length of time the router waits for a neighbor to reestablish
the LDP session.
host1(config)#mpls ldp graceful-restart timers neighbor-liveness 150
Related Topics Basic MPLS Configuration Tasks on page 276•
• Additional LDP Configuration Tasks on page 288
• mpls ldp graceful-restart
• mpls ldp graceful-restart reconnect-time
• mpls ldp graceful-restart recovery-time
• mpls ldp graceful-restart timers max-recovery
• mpls ldp graceful-restart timers neighbor-liveness
Configuring LDP Autoconfiguration
LDP autoconfiguration enables you to ensure that LDP is configured on all interfaces
running the IGP (IS-IS or OSPFv2). Using this command prevents you from having to
configure LDP individually on each interface in the IGP. You can prevent LDP from being
enabled on selected interfaces by issuing the no mpls ldp autoconfig command on the
interface.
When autoconfiguration is enabled for IS-IS, you can specify whether LDP is automatically
configured on all IS-IS interfaces in the virtual router or just the interfaces in a particular
IS-IS level. When autoconfiguration is enabled for OSPF, you can specify whether LDP
is automatically configured on all OSPF interfaces in the virtual router or just the interfaces
in a particular OSPF area.
To configure LDP autoconfiguration to ensure that LDP is configured on all interfaces
running the IGP:
•
Specify whether LDP is created automatically on the current interface or all interfaces:
•
Create LDP on all interfaces in the IGP router context
Copyright © 2010, Juniper Networks, Inc.290
JunosE 11.2.x BGP and MPLS Configuration Guide

Juniper JUNOSE 11.2.X BGP AND MPLS Specifications

General

Brand	Juniper
Model	JUNOSE 11.2.X BGP AND MPLS
Category	Software
Language	English