EasyManuals Logo
Home>Juniper>Software>JUNOSE 11.2.X BGP AND MPLS

Juniper JUNOSE 11.2.X BGP AND MPLS User Manual

Juniper JUNOSE 11.2.X BGP AND MPLS
742 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #548 background imageLoading...
Page #548 background image
Framework for Pseudo Wire Emulation Edge-to-Edge
(PWE3)—draft-ietf-pwe3-arch-06.txt (April 2004 expiration)
IEEE 802.3ad (Link Aggregation)
Pseudowire Setup and Maintenance Using
LDP—draft-ietf-pwe3-control-protocol-08.txt (January 2005 expiration)
Requirements for Pseudo-Wire Emulation Edge-to-Edge
(PWE3)—draft-ietf-pwe3-requirements-08.txt (June 2004 expiration)
Transport of Layer 2 Frames Over MPLS—draft-martini-12circuit-trans-mpls-11.txt
(October 2003 expiration)
NOTE: IETF drafts are valid for only 6 months from the date of issuance. They must be
considered as works in progress. Please refer to the IETF Web site at http://www.ietf.org
for the latest drafts.
For information about configuring supported layer 2 interfaces, consult the following
resources:
JunosE Physical Layer Configuration Guide
See Configuring ATM in JunosE Link Layer Configuration Guide.
See Configuring Frame Relay in JunosE Link Layer Configuration Guide.
See Configuring Packet over SONET in JunosE Link Layer Configuration Guide.
See Configuring Bridged Ethernet in JunosE Link Layer Configuration Guide.
For information about configuring supported serial interfaces, which are also referred to
as HDLC channels, see the following resources:
See Configuring Channelized T3 Interfaces in JunosE Physical Layer Configuration Guide.
See Configuring T3 and E3 Interfacesin JunosE Physical Layer Configuration Guide.
See Configuring Channelized OCx/STMx Interfaces in JunosE Physical Layer Configuration
Guide.
For information about configuring MPLS, see “Configuring MPLS” on page 275.
Related Topics Layer 2 Services over MPLS Platform Considerations on page 510
Layer 2 Services over MPLS Overview on page 509
Layer 2 Services over MPLS Implementation on page 512
Layer 2 Services over MPLS Implementation
When layer 2 services are configured over MPLS, layer 2 traffic is encapsulated in MPLS
frames and sent over MPLS tunnels. A virtual circuit (VC) label that indicates a specific
Copyright © 2010, Juniper Networks, Inc.512
JunosE 11.2.x BGP and MPLS Configuration Guide

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Juniper JUNOSE 11.2.X BGP AND MPLS and is the answer not in the manual?

Juniper JUNOSE 11.2.X BGP AND MPLS Specifications

General IconGeneral
BrandJuniper
ModelJUNOSE 11.2.X BGP AND MPLS
CategorySoftware
LanguageEnglish

Related product manuals