BFD is enabled:
Single-hop IPv4 BFD session to 1.2.3.4
Minimum transmit interval is 300 ms
Minimum receive interval is 300 ms
Multiplier is 3
BFD session is down
• Fields relevant to BFD when BFD is configured, the BGP session is established, and
the BFD protocol session is up:
BFD is enabled:
Single-hop IPv4 BFD session to 1.2.3.4
Minimum transmit interval is 300 ms
Minimum receive interval is 300 ms
Multiplier is 3
BFD session is up for 00:00:50
Negotiated detection time is 900 ms
• Fields relevant to conditional advertisement:
Advertise-map is advertisetoR1
Condition-map: trigger1
Sequence: 5
Status: Withdraw
Advertise-map is alternatetoR1
Condition-map: trigger2
Sequence: 10
Status: Advertise
Meaning Table 35 on page 182 lists the show ip bgp neighbors command output fields.
Table 35: show ip bgp neighbors Output Fields
Field DescriptionField Name
BGP identifier of the BGP neighborBGP neighbor ID
Remote AS of the BGP neighborremote AS
Textual description of the BGP neighborDescription
Name of the peer group of which this BGP neighbor is a memberMember of peer group
Router ID of the remote routerRemote router ID
BGP version being used to communicate with the neighbornegotiated BGP version
Desired state of the peer connectionAdministrative status
Current state of the BGP connectionConnection state
Time that TCP connection was establishedConnection has been
established
Reason for last reset of the BGP sessionReason for last reset
Copyright © 2010, Juniper Networks, Inc.182
JunosE 11.2.x BGP and MPLS Configuration Guide
To Next Page
Loading...
Need help?
General
