Juniper JUNOSE 11.2.X BGP AND MPLS User Manual

! Configure VPLS instance vplsA.
host1(config)#bridge vplsA vpls transport-virtual-router default
!
! Configure VPLS instance vplsB.
host1(config)#bridge vplsB vpls transport-virtual-router default
!
! Configure Fast Ethernet interface 2/1 between PE 1 and CE 1,
! and assign it to vplsA as a trunk interface.
host1(config)#interface fastEthernet 2/1
host1(config-if)#bridge-group vplsA subscriber-trunk
host1(config-if)#exit
!
! Configure bridged Ethernet interface 6/0.12 between PE 1 and CE 2,
! and assign it to vplsB as a trunk interface.
host1(config)#interface atm 6/0.12 point-to-point
host1(config-subif)#atm pvc 12 0 12 aal5snap 0 0 0
host1(config-subif)#encapsulation bridge1483 mac-address 0090.1a40.9991
host1(config-subif)#bridge-group vplsB subscriber-trunk
host1(config-if)#exit
!
! Configure LDP signaling for vplsA.
host1(config)#mpls ldp vpls vplsA vpls-id 1
host1(config)#mpls ldp vpls vplsA neighbor 2.2.2.2
! Configure LDP signaling for vplsB.
host1(config)#mpls ldp vpls vplsB vpls-id 2
host1(config)#mpls ldp vpls vplsB neighbor 2.2.2.2
!
! Configure a loopback interface on PE 1 and assign it an IP address.
host1(config)#interface loopback 0
host1(config-if)#ip address 1.1.1.1 255.255.255.255
host1(config-if)#exit
!
! Assign the router ID for PE 1 using the IP address of the loopback interface.
host1(config)#ip router-id 1.1.1.1
!
! Configure ATM core-facing interface 6/0.10 between PE 1 and the P router,
! and assign it an IP address.
host1(config)#interface atm 6/0.10 point-to-point
host1(config-subif)#atm pvc 10 0 10 aal5snap 0 0 0
host1(config-subif)#ip address 10.10.10.1 255.255.255.0
!
! Enable MPLS, LDP, and topology-driven LSPs on the core-facing interface.
host1(config-subif)#mpls
host1(config-subif)#mpls ldp
host1(config-subif)#exit
!
! Configure OSPF routing in the core MPLS network.
host1(config)#router ospf 1
host1(config-router)#network 1.1.1.1 0.0.0.0 area 0.0.0.0
host1(config-router)#network 10.10.10.0 0.0.0.255 area 0.0.0.0
host1(config-router)#exit
Configuration on PE 2 (Remote PE Router)
Use the following commands on the remote PE router (PE 2) to configure the VPLS
topology shown in Figure 130 on page 606.
607Copyright © 2010, Juniper Networks, Inc.
Chapter 12: Configuring VPLS

Juniper JUNOSE 11.2.X BGP AND MPLS Specifications

General

Brand	Juniper
Model	JUNOSE 11.2.X BGP AND MPLS
Category	Software
Language	English