6. (Optional) Configure preemption hold or setup priority.
host1(config-if)#tunnel mpls traffic-eng priority 4 4
7. (Optional) Configure resource class affinity.
host1(config-if)#tunnel mpls traffic-eng affinity 0x000C3000 0xFFFFFFFC
This example of a masked affinity matches only links configured with attribute flags
from 0x000C3000 to 0x000C3003.
8. (Optional) Configure retry timer options to apply to a specific tunnel to set up an
LSP after a route or setup failure.
host1(config-if)#tunnel mpls no-route retries 100
host1(config-if)#tunnel mpls no-route retry-time 45
host1(config-if)#tunnel mpls retries 250
host1(config-if)#tunnel mpls retry-time 65
9. (Optional) Associate a text description with the tunnel.
host1(config-if)#tunnel mpls description southshore
10. Configure the tunnel endpoint.
host1(config-if)#tunnel destination 10.12.21.5
Related Topics MPLS Global Configuration Tasks on page 277•
• MPLS Interface Configuration Tasks on page 281
• MPLS Tunnel Configuration Tasks on page 283
• MPLS Tunnel Profile Configuration Tasks on page 285
• Additional LDP Configuration Tasks on page 288
• Additional RSVP-TE Configuration Tasks on page 293
• interface tunnel
• tunnel destination
• tunnel mpls affinity
• tunnel mpls autoroute announce
• tunnel mpls autoroute metric
• tunnel mpls bandwidth
• tunnel mpls description
• tunnel mpls no-route retries
• tunnel mpls no-route retry-time
• tunnel mpls path-option
• tunnel mpls priority
• tunnel mpls retries
• tunnel mpls retry-time
Copyright © 2010, Juniper Networks, Inc.284
JunosE 11.2.x BGP and MPLS Configuration Guide
To Next Page
Loading...
Need help?
General
