7: TSP command reference Series 2600B System SourceMeter® Instrument
7-24 2600BS-901-01 Rev. B / May 2013
Usage
measurerange = bufferVar.measureanges[N]
The measurement range used to acquire reading number N in the specified buffer
The reading buffer; can be a dynamically allocated buffer (user-defined), or a
dedicated reading buffer (such as
)
bufferVar
Details
The measureranges buffer recall attribute is like an array (a Lua table) of full-scale range values for the
measure range used when the measurement was made.
For dedicated reading buffers, all buffer attributes are saved to nonvolatile memory only when the reading buffer
is saved to nonvolatile memory.
Example
measurerange = smua.nvbuffer1.measureranges[1]
Store the measure range that was
used to make reading number 1.
printbuffer(1, 10, smua.nvbuffer1.measureranges)
Print the range values that were used
for the first 10 readings saved in
source-measure unit (SMU) A,
dedicated reading buffer 1.
Example output:
1.00000e-07, 1.00000e-07,
1.00000e-07, 1.00000e-07,
1.00000e-07, 1.00000e-07,
1.00000e-07, 1.00000e-07,
Also see
bufferVar.measurefunctions (on page 7-22)
bufferVar.n (on page 7-24)
bufferVar.readings (on page 7-25)
bufferVar.sourcefunctions (on page 7-26)
bufferVar.sourceoutputstates (on page 7-27)
bufferVar.sourceranges (on page 7-28)
bufferVar.sourcevalues (on page 7-29)
bufferVar.statuses (on page 7-30)
bufferVar.timestamps (on page 7-32)
Reading buffers (on page 3-6)
bufferVar.n
This attribute contains the number of readings in the buffer.
Type TSP-Link accessible Affected by Where saved Default value
Usage
numberOfReadings = bufferVar.n
The number of readings stored in the buffer
The reading buffer; can be a dynamically allocated user-defined buffer or a
dedicated reading buffer
To Next Page
Loading...
Need help?
General
