Keithley 2601B Reference Manual

Section
7: TSP command reference Series 2600B System SourceMeter® Instrument
Reference Manual
7-376 2600BS-901-01 Rev. B / May 2013
tspnet.tsp.runscript()
This function loads and runs a script on a remote TSP-enabled instrument.
Type TSP-Link accessible
Affected by Where saved Default value
Function
Yes
Usage
tspnet.tsp.runscript(connectionID, script)
tspnet.tsp.runscript(connectionID, name, script)
connectionID
Integer value used as an identifier for other
tspnet
commands
name
The name that is assigned to the script
script
The body of the script as a string
Details
This function is appropriate only for TSP-enabled instruments.
This function downloads a script to a remote instrument and runs it. It automatically adds the appropriate
loadscript and endscript commands around the script, captures any errors, and reads back any prompts.
No additional substitutions are done on the text.
The script is automatically loaded, compiled, and run.
Any output from previous commands is discarded.
This command does not wait for the script to complete.
If you do not want the script to do anything immediately, make sure the script only defines functions for later use.
Use the tspnet.execute() function to execute those functions at a later time.
If no name is specified, the script is loaded as the anonymous script.
Example
tspnet.tsp.runscript(myconnection, "mytest",
"print([[start]]) for d = 1, 10 do print([[work]]) end print([[end]])")
Load and run a script entitled mytest on the TSP-enabled instrument connected with myconnection.
Also see
tspnet.execute() (on page 7-369)
tspnet.write()
This function writes a string to the remote instrument.
Type TSP-Link accessible
Affected by Where saved Default value
Function
No
Usage
tspnet.write(connectionID, inputString)
connectionID
The connection ID returned from tspnet.connect()
inputString
The string to be written

Keithley 2601B Specifications

General

Brand	Keithley
Model	2601B
Category	Measuring Instruments
Language	English