Keithley 2601B - Opc(); Os.remove()

Section
7: TSP command reference Series 2600B System SourceMeter® Instrument
Reference Manual
7-150 2600BS-901-01 Rev. B / May 2013
opc()
This function sets the operation complete status bit when all overlapped commands are completed.
Type TSP-Link accessible
Affected by Where saved Default value
Function
No
Usage
opc()
Details
This function causes the operation complete bit in the Standard Event Status Register to be set when all
previously started local overlapped commands are complete.
Note that each node independently sets its operation complete bits in its own status model. Any nodes that are
not actively performing overlapped commands set their bits immediately. All remaining nodes set their own bits
as they complete their own overlapped commands.
Also see
Status model (on page 5-14, on page E-1)
waitcomplete() (on page 7-380)
os.remove()
This function deletes the file or directory with a given name.
Type TSP-Link accessible
Affected by Where saved Default value
Function Yes
Usage
success, msg = os.remove(filename)
success
A success indicator (true or nil)
msg
A message value (nil or an error message)
filename
A string representing the name of the file or directory to delete
Details
Directories must be empty before using the os.remove() function to delete them.
If this function fails, it returns nil (for success) and an error message string (for msg).
Example
os.remove("testFile")
Delete the file named
testFile
.
Also see
os.rename() (on page 7-151)