To Next Page

To Previous Page

Series 2600B

System SourceMeter® Instrument Reference Manual Section 7:

TSP command reference

2600BS-901-01 Rev. B / May 2013 7-357

Example

tsplink.trigger[2].clear()

Clears trigger event on synchronization line 2.

Also see

tsplink.trigger[N].mode (on page 7-358)

tsplink.trigger[N].overrun (on page 7-359)

tsplink.trigger[N].release() (on page 7-360)

tsplink.trigger[N].stimulus (on page 7-362)

tsplink.trigger[N].wait() (on page 7-364)

tsplink.trigger[N].EVENT_ID

This constant identifies the number that is used for the trigger events. This constant is not available on the Models

2604B/2614B/2634B.

Type TSP-Link accessible

Affected by Where saved Default value

Constant

Yes

Usage

eventID = tsplink.trigger[N].EVENT_ID

eventID

The trigger event number

The trigger line (1 to 3)

Details

This number is used by the TSP-Link trigger line when it detects an input trigger.

Set the stimulus of any trigger object to the value of this constant to have the trigger object respond to trigger

events from this line.

Example

trigger.timer[1].stimulus = tsplink.trigger[2].EVENT_ID

Sets the trigger stimulus

of trigger timer 1 to the

TSP-Link trigger 2 event.

Also see

None

Keithley 2601B Reference Manual

Other manuals for Keithley 2601B