GENERAL WORKING PRECAUTIONS
• When servicing, observe the safety regulations in
the operator's manual and workshop manual.
•
Clean the machine before maintenance.
• Before working, remove the negative (-) terminal
from the battery or turn off the battery isolator
switch.
• Disassemble the machine at a clean location.
• Whenever a special tool is required, use the special
tool that Kubota recommends. Or, craft the special
tools according to the illustrations in this manual.
• Use genuine Kubota parts to ensure safety and
machine performance.
1. Tightening bolts and nuts
(A) Alternately
(B) Diagonally
(C) Diagonally from center to
outside
• T
ighten the bolts and nuts with their specified
torque.
NOTE
– Tighten the bolts and nuts alternately from
top to bottom and left to right so the torque
is distributed evenly.
– Gradually tighten the bolts and nuts two or
three times.
2. Applying thread-locking fluid
1. Clean and dry the location where a thread-locking
fluid
will be applied with a solvent to remove
moisture, oil, and dirt.
2. Apply the thread-locking fluid to the tip of the bolt.
3. If the threads are large, apply the thread-locking
fluid all around the bolt hole.
(A) Bolt hole (bolts, nuts) (B) Screw hole
3. Installing circlips
(1) Circlip
(2)
Rounded side
(3)
Angular side
GENERAL WORKING PRECAUTIONS
1. Tightening bolts and nuts 2. GENERAL
D1803-CR-E4,D1803-CR-TE4,D1803-CR-TIE4,V2403-CR-E4,V2403-CR-TE4,V2403-CR-TE4BG,V2403-CR-TIE4
To Next Page
Loading...
Need help?
General