5. Fill new oil until the upper line on the dipstick (2).
Engine oil capacity
D1803-CR-E4
D1803-CR-TE4
D1803-CR-
TIE4
7.0 L
1.8 U.S.gals
1.5 Imp.gals
V2403-CR-E4
V2403-CR-TE4
V2403-CR-
TE4BG
V2403-CR-
TIE4
9.5 L
2.5 U.S.gals
2.1 Imp.gals
(2) Dipstick
2.2 Replacing oil filter cartridge
CAUTION
• Make sure that you stop the engine before you
replace the oil filter cartridge.
IMPORTANT
• To
prevent serious damage to the engine,
replacement element must be highly efficient.
Use only a Kubota genuine filter or its
equivalent.
Tools required
• Filter wrench
1. Remove the
oil filter cartridge (1) with the filter
wrench.
(1) Oil filter cartridge
2. Apply a thin layer of oil on the new cartridge gasket.
3. Install the new cartridge by hand.
NOTE
• Do not
tighten too much because it can
cause deformation of the rubber gasket.
4. Make sure that the engine oil does not flow through
the seal and read the oil level on the dipstick.
5. Fill the engine oil until the specified level.
NOTE
• After
you
replace the cartridge, the engine
oil usually decrease by a small level.
3. Check point of every 50 hours
3.1 Checking fuel hoses and clamp
bands
1. Check the fuel hose (1) and clamp (2) are damaged
or not.
2.
If the fuel hose (1) or clamp (2) is damaged, replace
it.
3. MAINTENANCE
CHECK AND MAINTENANCE
2.Check points of initial 50 hours
D1803-CR-E4,D1803-CR-TE4,D1803-CR-TIE4,V2403-CR-E4,V2403-CR-TE4,V2403-CR-TE4BG,V2403-CR-TIE4
To Next Page
Loading...
Need help?
General