POWER TRIM
Page 5C-46 90-828631R3 MARCH 1999
Oil Pump Installation
1. Install spring, ball, lubricated O-ring and plastic seat to manifold.
2. Check to see that O-rings are placed on bottom of pump.
3. Install filter and filter seal under pump. Install pump onto manifold. Torque screws to spe-
cified torque.
b
a
a-Screw (3)
b-Suction Seat Assembly
Screw Torque
70 lb-in. (7.7 Nm)
Pressure Operated Assembly Installation
IMPORTANT: Inspect poppet assembly for debris in the area shown. If debris is found
on poppet, replace poppet.
a
b
a-Debris Under Valve Tip
b-Rubber Seat
1. Lubricate O-rings.
To Next Page
Loading...
Need help?
General
