90-830234R3 DECEMBER 1997 LOWER UNIT - 6A-33
Gear Housing Pressure Test
1. Remove vent plug and install pressure test
gauge.
2. Pressurized housing to 10 to 12 psi (68-82kPa)
and observe gauge for 5 minutes.
3. Rotate drive shaft, prop shaft and move shift
shaft while housing is pressurized to check for
leaks.
4. If pressure drop is noted, immerse housing in
water.
5. Re-pressurize to 10 to 12 psi (68-82kPa) and
check for air bubbles.
6. Replace leaking seals as necessary. Retest
housing.
NOTE: Gearcase should hold 10 to 12 psi (68-82
kPa) for 5 minutes.
7. Remove tester from housing and install vent
plug. Torque vent screw to 60 lb. in. (6.8 N·m).
Filling Gear Housing With
Lubricant
NOTE: Gear housing lubricant capacity is 22.5 fl. oz.
(665.2ml).
WARNING
If gear housing is installed on engine, to avoid ac-
cidental starting, disconnect (and isolate) spark
plug leads from spark plugs before working near
the propeller.
CAUTION
Do not use automotive grease in the gear hous-
ing. Use only Quicksilver Gear Lube or Quicksil-
ver Super-Duty Lower Unit Lubricant.
1. Remove any gasket material from “Fill” and
“Vent” screws and gear housing.
2. Install new gaskets on “Fill” and “Vent” screws.
IMPORTANT: Never apply lubricant to gear hous-
ing without first removing “Vent” screws or gear
housing cannot be filled because of trapped air.
Fill gear housing only when housing is in a verti-
cal position.
3. Insert lubricant tube into “Fill” hole.
4. Fill gear housing with lubricant until excess starts
to flow out of one (first) “Vent” screw hole.
To Next Page
Loading...
Need help?
General
