-
269
-
g) When "LOWER LIMIT " is selected (valid during cooling, dry, fan, automatic)
1 Indication:
SET UP LOWER 18°C "
2 Select the upper limit value with temperature setting button . Indication example: "LOWER 24°C "
(blinking)
3 Press
(SET) button to fix. Indication example: "LOWER 24°C" (Displayed for two seconds)
After the fixed upper limit value displayed for two seconds, the indication will return to "LOWER LIMIT
".
h) Press
button.
(d) Trail operation of drain pump
Drain pump operation from remote control unit is possible. Operate a remote control unit by following the steps described below.
1) To start a forced drain pump operation.
1 Press the
button for three seconds or longer.
The display will change “
”
2 Press the button once and cause “ ” to be displayed.
3 When the (SET) button is pressed, a drain pump operation will start.
Display: “
”
2) To cancel a drain pump operation.
1 If either
(SET) or button is pressed, a forced drain pump operation will stop. The air conditioning
system will become OFF.
66
IIf two (2) remote controllers are connected to one (1) inside unit, only the master controller is available for trial opera-
tion and confirmation of operation data. (The slave remote controller is not available.)
Previous button
It is possible to finish by pressing
ON/OFF button on the way, but
unfinished change of setting is
unavailable.
During setting, if you press
(RESET) button, you return to the
previous screen.
f-
g-
b, d
h
cef
a
To Next Page
Loading...
Need help?
General
