5 From the Chassis
property tree, view the following properties and their values:
• Bnk1:<device>: Transferred software in bank 1.
• Bnk2:<device>: Transferred software in bank 2.
• <device>: Installed and Running Software.
NOTICE: The Table format can be used (instead of the Diagram format) to view the
Installed and Running Software in the Device
view.
3.8.3.4
Disabling FTP Service
When and where to use: Follow this procedure to disable the FTP service after the transfer and
installation of the software is completed.
Procedure:
1 Launch a Secure SHell (SSH) terminal server session in PuTTY to access the Unified Network
Configurator (UNC) UNC Server Administration menu. See the Securing Protocols with SSH
manual.
2 From the UNC Server Administration menu, select Unix Administration. Press
ENTER.
3 From the Unix Administration menu, select FTP Services. Press ENTER.
4 From the FTP Services menu, select Disable FTP service. Press ENTER.
The FTP services are disabled and unavailable for software transfer and install operations.
5 To back out of the menus, press Q three times.
6 At the prompt, enter: exit to return to the previous menu.
7 To log out of the application, enter: exit.
8 Close the PuTTY connection.
MN003286A01-E
Chapter 3: GTR 8000 Base Radio Installation
131
To Next Page
Loading...
Need help?
General