Motorola ASTRO 25 GTR 8000 User Manual

3 Enter the pairing number. Click OK.
The pairing number is set.
4.4.5.2
Setting the Date and Time in CSS
This procedure provides the date and time to the device.
When and where to use: During installation, the date and time is set through an Ethernet cable
connected directly to the Ethernet port of the device. After installation, this procedure may be
performed remotely.
NOTICE: If a power outage occurs, the device does not retain the date and time settings.
Procedure:
1 Connect to the device using CSS through an Ethernet port link. See Connecting Through an
Ethernet Port Link
on page 140.
2 From the menu, select Tools → Set Device Date and Time.
3 Enter the current date and time. Click OK.
The date and time are set.
4.4.5.3
Changing SNMPv3 Configuration and User Credentials in CSS
Prerequisites: Obtain the required SNMPv3 credentials information (Authentication passphrase,
Encryption passphrase, and Authoritative Engine ID) to configure the device before proceeding. The
user credentials information includes both the current and new credentials. Without the current
credentials, you cannot access the device and cannot change the user credentials. See Local
Password and SNMPv3 Passphrase Troubleshooting on page 218. Changing to the incorrect user
credentials may lead to not being able to access the device from the Unified Network Configurator
(UNC), or for the device to be unable to send alarms to the Unified Event Manager (UEM) (for fault
management).
When and where to use: This procedure changes the SNMPv3 configuration and user credentials
from Configuration/Service Software (CSS) on a selected device in the site. For more information on
this feature, see the SNMPv3 manual.
NOTICE: During installation, perform this procedure through an Ethernet cable connected
directly to the Ethernet port of the device. After installation, this procedure may be performed
remotely from CSS.
Procedure:
1 Connect to the device using CSS through an Ethernet port link. See Connecting Through an
Ethernet Port Link
on page 140.
2 From the menu, select Security → SNMPv3 Configuration → Configure SNMPv3 Users
(Ethernet).
The SNMPv3 Passphrase Prompt dialog box appears with MotoAdmin as the selected
SNMPv3 user.
3 In the SNMPv3 Passphrase Prompt, enter the appropriate Authentication and Encryption
Passphrases in the text fields.
MN003286A01-E
Chapter
4: GTR 8000 Base Radio Configuration
143

Motorola ASTRO 25 GTR 8000 Specifications

General

Brand	Motorola
Model	ASTRO 25 GTR 8000
Category	Radio
Language	English