Figure 105: EMI Spring Panel Guide Rail Alignment
20 Using a T20 bit, reinstall the screw into the EMI spring panel tab.
21 Slide the transceiver and power amplifier modules into the new backplane. A slight push may be
needed to fully engage the modules.
22 Reconnect all cables to the front ports on the transceiver, if applicable.
23 Using a T20 bit, secure the transceiver and power amplifier modules to the chassis with the two
captive screws on the front of each module.
24 Reinstall the fan assembly. See Replacing the Fan Assembly on page 237.
25 Slide the power supply into the chassis, pushing gently until it securely seats in the new
backplane.
NOTICE: If the power supply does not seat properly, remove it and adjust the EMI spring
panel properly against the mounting flange.
26 Using a T20 bit, tighten the two captive screws on the front of the power supply.
27 Reconnect all cables at the rear of the base radio.
28 Set the power supply rocker switch to On (I).
29 Verify that the LEDs indicate the modules you removed and reinstalled are operational:
MN003286A01-E
Chapter 9: GTR 8000 Base Radio FRU Procedures
249
To Next Page
Loading...
Need help?
General