NETGEAR GC110 User Manual

Configure Switching
124
Insight Managed 8-Port Gigabit Ethernet Smart Cloud Switch with 2 SFP Fiber Ports
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Access the Switch on page 11.
The login window opens.
4. Enter the switch’
s password in the password field.
The default password is password. If you added the switch to a network on the Insight
app before and you did not yet change the password through the local browser interface,
enter your Insight network password.
The System Information page displays.
5. Select Switching > STP >
Advanced > CST Port Configuration.
6. To display information for all ports and LAGs, click the All link.
7. Select one or more interfaces by taking one of the following actions:
• To configure a single interface, select the check box associated with the port, or type
the port number in the Go To Interface field and click the Go button.
• T
o configure multiple interfaces with the same settings, select the check box
associated with each interface.
• T
o configure all interfaces with the same settings, select the check box in the heading
row.
8. From the STP Status menu, select the option to enable or disable the spanning tree
administrative mode associated with the port or port channel.
The possible values are Enable and Disable.
The default value is Enable.
9. From the Fast Link menu, select whether the specified port is an edge port within the CST
.
The possible values are Enable and Disable.
The default value is Disable.
10. From the BPDU Forwarding menu, configure BPDU forwarding.
The possible values are Enable and Disable.
The default value is Disable. When BPDU
forwarding is enabled, the switch forwards the BPDU traffic arriving on this port when
STP is disabled on this port.
11. From the Auto Edge menu, specify if the port is allowed to become an edge port if it does
not detect BPDUs for some duration.
The possible values are Enable and Disable. The default value is Enable.
12. In the Path Cost field, set the path cost to a new value for the specified port in the common
and internal spanning tree.

NETGEAR GC110 Specifications

General

Switch type	Managed
Quality of Service (QoS) support	Yes
Console port	RJ-45
Power connector	DC-in jack
SFP module slots quantity	2
Installed SFP modules quantity	-
Basic switching RJ-45 Ethernet ports type	Gigabit Ethernet (10/100/1000)
Basic switching RJ-45 Ethernet ports quantity	8
Product color	Gray
10G support	No
MAC address table	- entries