NETGEAR GC110 User Manual

Configure Switching
159
Insight Managed 8-Port Gigabit Ethernet Smart Cloud Switch with 2 SFP Fiber Ports
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Access the Switch on page 11.
The login window opens.
4. Enter the switch’s password in the password field.
The default password is password. If you added the switch to a network on the Insight
app before and you did not yet change the password through the local browser interface,
enter your Insight network password.
The System Information page displays.
5. Select Switching > Address Table > Basic > Address Table.
The MAC Address Table page displays.
6. Use the Search menu and field to search for a MAC address, VLAN ID, or interface number
and display the information:
• Search by MAC Address. From the Search menu, select MAC Address, and enter
the 6-byte hexadecimal MAC address in two-digit groups separated by colons, for
example, 01:23:45:67:89:AB. Then click the Go button.
If the address exists, that entry is displayed as the first entry followed by the
remaining (higher) MAC addresses. An exact match is required.
• Search by VLAN ID. From the Search menu, select VLAN ID, and enter the VLAN ID,
for example, 100. Then click the Go button.
• Search by Interface. From the Search menu, select Interface, and enter the
interface ID using the respective interface naming convention (for example, g1 or l1).
Then click the Go button.
7. To refresh the information on the page, click the Refresh button.
The following table describes the nonconfigurable information displayed on the page.
Table 45. MAC Address Table information
Field Description
Total MAC Address The number of total MAC addresses learned or configured.
VLAN ID The VLAN ID associated with the MAC address.
MAC Address The unicast MAC address for which the switch holds forwarding, filtering information, or
both. The format is a 6-byte MAC address that is separated by colons, for example
01:23:45:67:89:AB.

NETGEAR GC110 Specifications

General

Switch type	Managed
Quality of Service (QoS) support	Yes
Console port	RJ-45
Power connector	DC-in jack
SFP module slots quantity	2
Installed SFP modules quantity	-
Basic switching RJ-45 Ethernet ports type	Gigabit Ethernet (10/100/1000)
Basic switching RJ-45 Ethernet ports quantity	8
Product color	Gray
10G support	No
MAC address table	- entries