NETGEAR GC110 User Manual

Manage Power over Ethernet
313
Insight Managed 8-Port Gigabit Ethernet Smart Cloud Switch with 2 SFP Fiber Ports
8. Click the Apply button.
Your settings are saved.
The following table describes the nonconfigurable fields on the PoE Port Configuration
page.
Detection Type The detection type specifies how the port detects the attached PD. Select one of
the following types:
• IEEE 802. The port performs a 4-point resistive detection. This is the default
setting.
• 4pt 802.3af + Legacy. The port performs a 4-point resistive detection, and if
required, continues with legacy detection.
• Legacy. The port performs legacy detection.
Timer Schedule If you set up a PoE timer schedule, you can assign it to the port by selecting the
schedule from the Timer Schedule menu.
For information about PoE timer schedules, see Set Up PoE Timer Schedules on
page 315. By default, the selection from the menu is None.
If you want to remove a previously assigned timer schedule, select None from the
Timer Schedule menu.
Field Description
High Power If a port supports High Power mode, the field displays Yes.
Max Power (mW) The maximum power in milliwatts that the port can provide.
Class The class defines the range of power a powered device (PD) is drawing from the
switch. The class definitions are as follows:
• 0: 0.44–16.2W
• 1: 0.44–4.2W
• 2: 0.44–7.4W
• 3: 0.44–16.2W
• 4: 0.44–31.6W
• Unknown. The class cannot be detected, or no PD is attached to the port.
Output Voltage (Volts) The voltage that is delivered to the PD in volts.
Output Current (mA) The current that is delivered to the PD in mA.
Output Power (W) The power that is delivered to the PD in watts.
Status The operational status of the port. The possible values are as follows:
• Disabled. No power is delivered.
• Delivering Power. Power is being drawn by the PD.
• Requesting Power. The port is requesting power.
• Fault. A problem occurred with the power.
• Test. The port is in test mode.
• Other Fault. The port is idle because of an error condition.
• Searching. The port is not in one of the other states in this list.
Menu Item Description

NETGEAR GC110 Specifications

General

Switch type	Managed
Quality of Service (QoS) support	Yes
Console port	RJ-45
Power connector	DC-in jack
SFP module slots quantity	2
Installed SFP modules quantity	-
Basic switching RJ-45 Ethernet ports type	Gigabit Ethernet (10/100/1000)
Basic switching RJ-45 Ethernet ports quantity	8
Product color	Gray
10G support	No
MAC address table	- entries