12
9850045 R01 - 2020-2021 RANGER 1000 Service Manual
© Copyright Polaris Inc.
12.33
The battery must be fully charged before use or battery
life will be significantly reduced by 10-30% of the
battery's full potential.
To charge a Lead Acid Conventional battery, do the
following:
1. Remove the battery from the vehicle to prevent
damage from leaking or spilled acid during charging
(see Battery Removal).
2. Charge the battery with a charging output no larger
than 10% of the battery's amp-hour rating. Charge as
needed to raise the specific gravity to 1.270 or
greater.
3. Install the battery (see Battery Installation).
Test the battery using the PU-50296 battery tester. If the
test fails, fully charge the battery.
LEAD ACID CONVENTIONAL BATTERY
MAINTENANCE
Recharge the battery to its full capacity every 30 to 60
days.
If the battery is stored or used in a partially charged
condition, hard crystal sulfation will form on the plates,
reducing the efficiency and service life of the battery.
IMPORTANT
NEVER add electrolyte to the battery once the battery
is in service.
Only add distilled water to the battery if necessary.
Store the battery in the vehicle with the cables
disconnected, or store the battery in a cool / dry location.
Batteries will self discharge more rapidly when stored in
extreme temperatures.
DRY SHIPPED AGM BATTERY
DRY SHIPPED AGM BATTERY ACTIVATION
WARNING
ALWAYS wear safety glasses and protective gloves
when activating a battery. Clean all spills immediately.
To activate a Dry Shipped AGM battery, do the following:
1. Remove the battery from the vehicle and place on a
level surface.
2. Remove the electrolyte container from the package.
3. Remove the sealing strip on top of the battery.
IMPORTANT
Do not remove the sealing strip until ready to activate
the battery.
CHASSIS / BODY ELECTRICAL
To Next Page
Loading...
Need help?
General
