Chapter 3 Configuring Your Library
Obtaining and Installing a License Key
Scalar i500 User’s Guide 88
The paths to open the appropriate screens are as follows:
• From the Web client, select
Setup > Control Path.
• From the operator panel, select
Setup > Control Path.
Obtaining and Installing a License Key
Several features can be added to the standard library configuration either
with your initial purchase or afterward (see Licensable Features
on
page 32).
This section describes how to license these features on your library, in the
following sections:
• About License Keys
• Viewing Licenses and License Keys
• Obtaining a License Key
• Applying a License Key
Note: You may need to modify settings in your host application as a
result of modifying the control path. See your host application
documentation.
Note: Bold column headings in the table can be sorted. For example,
selecting the
Location column heading will sort by location
coordinates.
Note: If you have more than one FC I/O blade in the library, each FC
I/O blade will present each partition — that does not have a
tape drive as the control path — as a target device to the host.
Thus the host may see the same partition multiple times. To
minimize confusion, you should configure host mapping so
that each host sees each device only once. See Configuring
Host Mapping on page 118.
To Next Page
Loading...
Need help?
General