Chapter 10 Getting Information – Logs and Reports
Viewing, Saving, and E-mailing Library Logs
Scalar i500 User’s Guide 277
• Location — Location coordinates of the slot. (For a description of
location coordinates, see Understanding the Location Coordinates
on
page 32.)
•
Element Address — Element address of the slot.
•
Encryption — The encryption state of the media in the slot. In order
for the library to know the encryption state, the tape must have been
placed into an encryption-capable tape drive in the library. The
encryption-capable tape drive reads and records the encryption state
of the tape, and the encryption state displays as “Encrypted” or “Not
Encrypted.” If the tape was not placed into an encryption-capable
tape drive in the library, or if the slot is empty, the encryption state
displays as “Unknown.”
•Get Count — The number of times the picker successfully removed a
tape from the slot.
• Get Retries — The number of times the picker had to perform a
recovery operation to remove a tape from the slot.
• Put Count — The number of times the picker successfully placed a
tape into the slot.
• Put Retries — The number of times the picker had to perform a
recovery operation to place a tape into the slot.
The path to open the report from the Web client is
Reports > All Slots.
Viewing, Saving, and E-mailing Library Logs
The library collects specific information in log files that you can view
onscreen, save to your computer, or e-mail to a recipient. The following
library logs are available:
•
Installation Verification Test Summary Log — This log is saved each
time you run the Installation Verification Test (IVT). The log saves
only the information from the most recently run test. If you run the
Note: “Get” and “put” counts and retries are counted from the
beginning of library use to the present. If the LCB compact
flash card is replaced, the count starts over at zero.
To Next Page
Loading...
Need help?
General