Chapter 12 Installing, Removing, and Replacing
Preparing to Remove or Replace a Module
Scalar i500 User’s Guide 367
Figure 58 Library Configuration
Example 2
8 If a partition references tape drives within the module you are
removing or replacing, modify any affected partition by removing
the referenced drive elements from the partition. See Modifying
Partitions on page 73.
For example, in Figure Figure 57 on page 364, all partitions reference
drives in the expansion modules. In Figure Figure 58
on page 367,
Library_c was deleted, as well as its drive references in the expansion
To Next Page
Loading...
Need help?
General