Chapter 6 Storage Networking
Configuring Control Path Failover
Scalar i500 User’s Guide 155
Figure 20 Forcing Control Path
Failover
3 Select the partition on which you want to force the failover.
4 Click
Apply.
The new active tape drive location displays in the
Active Drive
column. The new standby tape drive location displays in the
Standby
Drive
column.
Active Connected
Whether the current control path tape drive
is connected and has a working link.
Standby Drive
Location of the standby tape drive.
Standby Status
Ready status of the standby tape drive.
Standby Connected
Whether the standby tape drive is connected
and has a working link.
Note: The standby tape drive must be “ready” and “connected”
in order to force a failover.
Column Indicates
To Next Page
Loading...
Need help?
General