Chapter 10 Getting Information – Logs and Reports
Viewing the System Information Report
Scalar i500 User’s Guide 271
Viewing the System Information Report
The System Information Report contains information on the following
library settings:
•
Date and time — current date, time, and time zone settings
•
Physical library — host name, Internet Protocol (IP) address(es), serial
number, firmware version, board support package (BSP) level, the
date the BSP was last updated, and robot firmware version.
•
Encryption (this section displays only if encryption key management
is licensed and configured on the library) — key server type;
encryption software version; SSL connection (enabled/disabled);
primary host (primary key server IP address or host name), primary
key server port number; primary key server serial number; secondary
host (secondary key server IP address or host name); secondary key
server port number; secondary key server serial number.
•
Library Partitions— name, serial number, control path, mode,
encryption method, encryption system type, number of slots, number
of media, number of tape drives, and whether FIPS is configured for
each partition.
•
Tape drives — location coordinates, vendor name, model, type,
physical serial number (P-SN), logical serial number (L-SN),
firmware level, sled boot version, sled application version,
encryption method, and whether the tape drive is connected to an
I/O blade.
•
FC I/O blades — if the library contains FC I/O blades, this table lists
the location coordinates, World Wide Node Name (WWNN),
firmware level, and ready status.
•
EE blades — if the library contains Ethernet Expansion blades, this
table lists the location coordinates and status.
The path to open the report from the Web client is
Reports > System
Information
.
To Next Page
Need help?
General
