Chapter 12 Installing, Removing, and Replacing
Installing the Library in a Rack
Scalar i500 User’s Guide 429
library configuration above, below, or between any expansion
modules. However, for recommended configuration, see Installing a
New Multi-Module Library Configuration on page 330.
Installing the Rackmount
Shelves 12
Required parts: Rackmount shelves, (8) ferrules, (8) thumbnuts
1 If the rackmount shelves are extended, collapse them to their smallest
size. It is easier to fit and position the shelves within the rack when
the shelves are compact.
2 Place a ferrule on the end of each stud, and screw it on completely.
The larger side of the ferrule should face the rack shelf, and the
tapered end should face out. Be sure to use the proper size ferrule as
described in Preparing for Installation
on page 424.
Note: Extending the shelves can be difficult, but they are
designed to be resized by hand. Do not use tools to resize
the shelves, and never take them apart.
1Stud
2Ferrule
To Next Page
Loading...
Need help?
General