Chapter 13 Troubleshooting
Saving and E-mailing the Library Configuration Record
Scalar i500 User’s Guide 493
• Fibre Channel (FC) tape drives—partition name, number of tape
drives in partition, drive location, SCSI element address, online
status, active status, ready state, vendor, model, serial number,
tape drive firmware version, drive type, logical serial number,
interface type, World Wide Node Name (WWNN) loop ID,
topology, speed, and actual speed.
• Serial Attached SCSI (SAS) tape drives—partition name, number
of tape drives in partition, drive location, SCSI element address,
interface type, drive type, ready state, online status, barcode,
media type, element address, vendor, model, physical serial
number, logical serial number, SCSI ID, firmware level, control
path status.
• I/O blade information—blade number, blade ID, location
coordinates, serial number, WWNN, firmware version, and
control LUN.
• Partition information—number of partitions, number of cleaning
slots, number of unassigned slots, number of import/export
(I/E) slots, I/E manual assignment setting, partition name,
number of slots, number of tape drives, and number of
cartridges.
E-mailing the
Configuration Record 13
Administrators can use the Tools - E-mail Configuration Record screen on
the Web client to e-mail the library configuration record.
Do not enter more than one e-mail address in the
E-mail Address text box
on the
Tools - E-mail Configuration Record screen. If you need to send the
configuration record to multiple e-mail addresses, repeat the procedure
for each e-mail address.
Before you can e-mail the configuration record, the library e-mail account
must be configured. For information on setting up the e-mail account, see
Configuring the Library E-mail Account
on page 92.
Note: If the FC tape drive is attached to an FC I/O blade, the
WWNN indicates the WWNN of the I/O blade, not
the tape drive.
To Next Page
Loading...
Need help?
General