Chapter 7 Encryption Key Management
Configuring Encryption Key Management on the Library
Scalar i500 User’s Guide 174
1 On the tape drives, install the latest version of firmware that is
qualified for the library firmware installed on your library. Refer to
the library release notes for the correct version of tape drive
firmware. (It is recommended that you upgrade library firmware to
the latest release.)
2 Unload tape cartridges from all tape drives in the partitions on which
you are configuring EKM.
Step 3: Configuring Encryption Settings and Key Server Addresses
7
Configure encryption settings and key server information as follows:
1 From the Web client, select Setup > Encryption > System
Configuration.
The Setup - Encryption System Configuration screen displays (see
Figure 25
).
To Next Page
Loading...
Need help?
General