Error Type Description Main Error
Breakdown or
failure error (SC)
An abnormal condition exists indicating
a breakdown that prevents the machine
from printing. After the cause of the
problem has been removed, the
machine must be cycled off/on to
restore normal operation. The machine
basically requires servicing (the
problem cannot be solved by the
operator).
See the "Error Code" table.
Print/Data Errors
The designated print operation cannot
function, or there is a print data error.
• Memory overrun
•
Work memory overrun
•
Data flow interruption
Diagnostic Error
The machine fails to operate due to a
problem with the CTL board or a
controller option.
•
Parallel interface error
•
Memory error
• Flash memory error
Temperature Range Errors
At power on
At power on, the printer is ready to
print and Ready status is maintained
Once the machine has entered the
usable temperature range that
guarantees optimum operation, the
machine automatically enters the
Ready status.
Printing…
Operation has been interrupted to wait
for the machine to resume the Ready
status.
Maintains machine Ready status. The
machine needs to be cycled off/on.
• Once the machine falls below or exceeds the usable temperature range, quality printing can no
longer be assured so an error message will alert the operator that printing will stop until normal
temperature has been restored.
• If such an error occurs, the machine should be moved to a location where ambient temperature is
10 to 32° C (50 to 89.6F).
Operation Panel Messages
1. Normal Status
6. Troubleshooting
200
To Next Page
Loading...
Need help?
General