13. [#Enter] x2 times> "-020"> [#Enter] To enter "2" at the 2nd zero, cursor moves to 3rd "0".
14. [ ] x5 times> "-025"> [#Enter]
FDLEN:OFFSET
-025
15. [#Enter] To save the setting.
SP No.
1001003
16. [Escape]> "Engine Maint."
17. [ /Menu] or [ ]> "End"> [#Enter]. The machine returns to standby mode.
-or-
If you changed a setting the machine may switch off. Press [Power] to switch the machine on again.
This enables the new setting(s).
Bit Switch Settings
Bit SW 1
Bit Function Default Details
0 Not Used --- ---
1 Periodical
straightening of the
transfer belt
0 The transfer belt is held under tension at all time, so
its bent part around the roller may become
deformed.
To prevent it, you can have the machine turn the
roller periodically to change the part of the transfer
belt in contact with the roller.
0: Straighten.
1: Do not straighten.
Service Mode, Engine Maintenance
27
To Next Page
Loading...
Need help?
General