After Replacement
After replacing the CLT board, you need to specify the serial number, PnP code, and destination, and
then initialize the VMRAM. Be sure to perform this in the order of (1) specifying the serial number, (2)
specifying the PnP code and destination, and (3) initializing the VMRAM.
(1) Serial number
1. Switch the machine on.
2. Enter the SP mode.
3. Select "Service Menu">"Serial No. Edit."> [#Enter].
00000000000
_
4. Enter the machine serial number.
• Press [ ] or [ /Menu] to move the cursor vertically, press [#Enter] to select the digit you
want to change (among 11 digits), press [ ] or [ /Menu] to change the character, and
then and then press [#Enter] to confirm the entry. The confirmed entry appears on the upper
row of the display.
5. After completing the entry, press [Escape].
6. Exit the SP mode.
(2) PnP code, Destination
1. Enter the SP mode.
2. Select "Engine Maint."> [#Enter].
SP No.
5907001
3. Enter "5907001"> [#Enter].
Plug & Play
5907001
4. Press [#Enter].
Plug & Play
_
0 Japan
Boards
83
To Next Page
Loading...
Need help?
General