30. The system will reboot. Press the Home button on the copier operation panel and wait for
5-10 minutes until the Fiery icon appears on the Home screen.
• During the 5-10 minutes, the diagnostic LED may remain displaying 'FF' for several times, but
this does not indicate an error.
31. Touch the Fiery icon and wait about a few minutes until the Fiery menu screen appears.
32. Press the Fiery tab to access Setup, and press Setup at the Fiery menu screen.
33. You are asked to enter the administrator password. (The default password is "Fiery.1".)
34. Input the customer's settings from the Configuration pages that you printed earlier. If
there exists some backup file created from the same E-24B unit, restore it after the
network configuration is completed. [Link to page 124 "Backup/Restore"]
• Ask the site administrator for the other settings that are not on the Configuration pages, You
must reboot the E-24B to apply the settings. For more information, see the "Configuration and
Setup" manual (http://help.efi.com/ricoh/docs/).
35. If you have been given any patches (system update files) for the version of system
software you have just installed, install the patches now. See the instructions provided
with each patch.
Installing System Software Using a USB Flash Drive
Preparation
To prepare a USB flash drive, which is bootable and includes system software, the following items
should be prepared:
•
E-24B System Software DVD
4. System Maintenance
110
To Next Page
Loading...
Need help?
General
