4. Touch “Restart Fiery”.
5. Touch “Shut Down”, then touch “OK”.
The E-24B enters into the shut down sequence.
The diagnostic LEDs on the rear panel of the E-24B will turn off.
6. Turn OFF the copier main power switch.
7. If the E-24B is being taken out of service, turn OFF the E-24B using its main power switch.
(For example, if someone needs to move the E-24B, disconnect cables, or open the
chassis.)
Shutting Down the E-24B Only
1. Make sure that the E-24B is not receiving, processing, or printing any jobs.
If "Printing" appears on the operation panel, the E-24B is processing. You must wait until the system
finishes and reaches Idle before restarting or shutting down.
If the system has just finished processing, wait at least five seconds after the system reaches Idle
before beginning the shutdown procedure.
2. General Operations For Servicing
60
To Next Page
Loading...
Need help?
General
