Network-2
Possible cause:
One of the following:
•
Normal behavior
System is searching for a nonexistent DHCP server.
DHCP is enabled by default on the E-24B, but the customer’s network is not using DHCP.
• If the customer’s network is using DHCP:
• Network cable or connection faulty
• Network is faulty
• Faulty Ethernet port on the motherboard
Suggested action:
1.
Request that the network administrator change the default in E-24B Network Setup.
2. If neither LED on the designated network port is lit on the E-24B, check the cable connection to
the E-24B and the network. Make sure that the cable is the correct type.
3. If the network cable is the correct type and is properly connected to the E-24B, connect a new
network cable to the E-24B.
4. Request that the network administrator check other devices on the network.
If other devices are not functioning, there could be a problem with the network.
5. Replace the motherboard.
Scanning
Scanning
Symptom:
Problems with scanning or sending files
Possible cause:
•
Loose, incorrect, or missing connection between the E-24B and copier
• The copier does not have an IP address
Suggested action:
1. Check and reseat the copier interface cable between the E-24B and the copier.
2. Turn the copier OFF then ON.
3. Replace the copier interface cable.
Errors and Suggested Actions
171
To Next Page
Loading...
Need help?
General
