Accessing Configure
Fiery System Settings can be configured/changed from the client PC using Configure, which can be
accessed from the following locations:
•
WebTools (with a supported Internet browser)
• Command WorkStation (utility software included in the User DVD)
Accessing Configure from WebTools
• The network settings (protocol, IP Address, etc) and the "Enable Web Service" option should be set
to ON (default) in order to access Configure from WebTools.
1. Open an Internet browser and type the IP address of the controller.
Supported Internet browsers:
•
Windows: Internet Explorer 11 or later, Firefox 31.0 or later, Chrome 37.0 or later
In addition, Microsoft Edge is supported for client computers that are running Windows 10
(not supported for other versions of Windows)
• Mac OS: Safari 7 or later, Firefox 31.0 or later, Chrome 37.0 or later
• Microsoft releases frequent updates to Internet Explorer. Because support cannot be
guaranteed for all versions, use the specified version for best results. On Mac OS, some
versions of Firefox may not allow you to enter passwords into Configure. If this occurs, use
Safari instead.
2. In WebTools, on the Configure tab, click Launch Configure.
• If a message about untrusted connections appears, or you are asked whether you want to
proceed, you can safely ignore the message and proceed anyway. For more information
about these messages, see Configuration and Setup (http://help.efi.com/ricoh/docs/).
2. General Operations For Servicing
68
To Next Page
Loading...
Need help?
General
