Service switch
position
LED status
code
Description
Backup b0 • To back up the E-24B by creating an image file.
•
When you start the backup process, the diagnostic LEDs
flash "b1", "b2", "b3" in one second intervals, and
repeats the cycle to indicate backup is in progress.
• When the backup process is complete, the diagnostic
LEDs cycle "bC", "00" in one second intervals and
repeats to indicate completion status. Remove the USB
flash drive at backup completion.
Restore
C0 • To restore the E-24B with the image file.
•
When you start the restore process, the diagnostic LEDs
flash "C1", "C2", "C3" in one second intervals, and
repeats the cycle to indicate restore is in progress.
• When the restore process is complete, the diagnostic
LEDs cycle "CC", "00" in one second intervals and
repeats to indicate completion status. Remove the USB
flash drive at restore completion.
Preparation
Before using Fiery Clone Tool, you must prepare a bootable USB flash drive for backing up and
restoring from image files. This can be done with the Fiery USB Setup Tool, version 2.x.x or later.
Items to Prepare:
•
Fiery USB Setup Tool Ver.2.0.25 or later (*1)
• Fiery Clone Tool for Embedded Servers Ver.3.2 or later (*1)
• Windows PC with the following specification.
• OS: Windows 7 or later
• Supports USB 3.0/2.0
• 256MB of available memory
Backup/Restore
143
To Next Page
Loading...
Need help?
General
