2. Press the Home button on the operation panel of the copier and then touch the Fiery icon.
The Fiery menu screen appears.
3. Move to the Fiery tab.
4. Touch “Restart Fiery”.
5. Touch “Shut Down”, then touch “OK”.
The E-24B enters into the shut down sequence.
The diagnostic LEDs on the rear panel of the E-24B will turn off.
6. If the E-24B is being taken out of service, turn OFF the E-24B using its main power switch.
(For example, if someone needs to move the E-24B, disconnect cables, or open the
chassis.)
Restarting the E-24B
When restarting the E-24B to recover from a problem, try this procedure first. However, this procedure
will only restart the E-24B application software that is now running on the system OS. To reboot the
system OS (for example, after downloading a patch), see the next section “Rebooting the E-24B [Link to
page 62 "Rebooting the E-24B"]”.
1. Make sure that the E-24B is not in use.
2. Press the Home button on the operation panel of the copier and then touch the Fiery icon.
The Fiery menu screen appears.
3. Move to the Fiery tab.
4. Touch “Restart Fiery”.
Start-Up, Shut-Down, and Reboot
61
To Next Page
Loading...
Need help?
General
